ThinkParametric

Back arrow Back to Forum

Explicit Modeling

Picture?type=large

almost 2 years ago by Awais Rauf

ExtrudeCrv - Solide=Yes and Cap are they the same?

After you extruded the curve, there was a gap in the wall and you used the cap command to fill the gap. (4:30). Is it the same as turning the solid option to yes in the extrude crv command? Thanks.



1 Answer

  • Picture?type=large

    Had I the patience to wait a minute before asking the question, my doubt would've been cleared. Thanks for being clear and concise in the videos.