Crv2view command is not working as demonstrates, the 2 halves of the railing are not joined when i perform it

Question

there is a space of a few cm between the two railing halves when i perform the crv2view command (e.g. in top view they don't reach the center of the arc). why could this be?

Arie Willem de Jongh · Accepted Answer

Hi Anastasiia!My best guess is that the arc was not split exactly at the center. To be fair the Crv2View can be quite stubborn and unpredictable at times. I could replicate your problem, were I split the arc not exactly at the middle. For some reason one of the sides was being done correct and on the other side a couple of centimeters was missing.  Unfortunately I have no idea why that is, I&#x27;m guessing a bug. Good luck and best,Arie

Forum

Explicit Modeling

Crv2view command is not working as demonstrates, the 2 halves of the railing are not joined when i perform it

1 Answers

Explicit Modeling

Crv2view command is not working as demonstrates, the 2 halves of the railing are not joined when i perform it

1 Answers